Differences

This shows you the differences between two versions of the page.

--- en:xboot:readme [2012/01/09 03:12]
alex [2.4 Notes for Main Application]
+++ en:xboot:readme [2012/01/09 03:59]
alex [2.2 Build XBoot and Program to Chip]
@@ Line 60: / Line 60: @@
 ==== - Build XBoot and Program to Chip ====
-To build XBoot, select a .conf.mk file from the conf directory and make sure the settings are appropriate for your chip, programmer, and configuration.  Then type "make [file].conf.mk".  This will copy [file].conf.mk to config.mk, generate config.h, compile the whole package, and generate xboot.hex, which can be downloaded with any programming cable capable of programming AVR chips.  If you have and XMEGA and want to save some time and just program the boot section, type "make xboot-boot.hex" and then write the new file xboot-boot.hex to the boot section directly with avrdude.  The makefile includes built-in support for avrdude, so all you need to do is modify the avrdude parameters in the .conf.mk file for the programmer you have and type "make program".
+To build XBoot, select a .conf.mk file from the conf directory and make sure the settings are appropriate for your chip, programmer, and configuration.  Then type "make [file].conf.mk".  This will copy [file].conf.mk to config.mk, generate config.h, compile the whole package, and generate xboot.hex, which can be downloaded with any programming cable capable of programming AVR chips.  If you have an XMEGA and want to save some time and just program the boot section, type "make xboot-boot.hex" and then write the new file xboot-boot.hex to the boot section directly with avrdude.  The makefile includes built-in support for avrdude, so all you need to do is modify the avrdude parameters in the .conf.mk file for the programmer you have and type "make program".
 Note that after typing "make [file].conf.mk", the settings from [file].conf.mk will remain active until either a new .conf.mk file is selected or "make clean" is run.